学校 工厂 红外测温门 LB-105门式红外测温仪
School Factory Infrared Thermometer LB-105 Door Infrared Thermometer
产品简介(Product introduction)
LB-105门式红外测温仪是一种特种设备,专用于疫情时期的出入境口岸、港口、机场、码头、车站、医院、学校、幼儿园、体育场馆、宾馆、娱乐场所及工厂等人群密集场合快速筛检人体体温。产品由一组热成像镜头24小时自动连续扫描测温的红外测温仪完成体温自动筛查工作,可以替代工作人员快速筛出人群中体温异常群体,提高通行效率,减轻工作人员的工作量,降低工作人员在疑似病患前的暴露风险。
LB105 Door Infrared Thermometer is a special type of equipment, which is specially used for entry and exit ports, ports, airports, terminals, stations, hospitals, schools, kindergartens, stadiums, hotels, entertainment venues and factories in epidemic periods Quickly screen your body temperature for occasions. The product uses a set of thermal imaging lenses to continuously scan and measure the temperature of the infrared thermometer to complete the automatic screening of body temperature. It can replace the staff to quickly screen out abnormal temperature groups in the crowd, improve traffic efficiency, and reduce the workload of staff. Reduce the risk of staff exposure before suspected patients.
安全守则(Safety code)
· 请在使用前仔细阅读本说明书;
· 本产品使用环境温度是10℃到30℃,最佳温度25℃,温度变化幅度<8℃;
· 请不要把本产品置于高于40℃或低于0℃的环境使用;
· 请不要在相对湿度大于80%的环境下使用本产品;
· 请不要将本产品在太阳下暴晒或靠近火炉,更不能接触到水;
· 请不要推撞踢打本产品,若有损坏请不要使用;
· 需要清洁时,请用酒精轻拭仪表表面;
· 一旦产品出现问题,请联系厂家,不要试图自行修理;
· Please read this manual carefully before use;
· The ambient temperature of this product is 10 ℃ ~ 30 ℃, the optimal temperature is 25 ℃, and the temperature variation range is <8 ℃;
· Do not use this product in an environment above 40 ° C or below 0 ° C;
· Do not use this product in an environment with relative humidity greater than 80%;
· Do not expose this product to the sun or near the stove, let alone contact with water;
· Do not kick or kick this product, if it is damaged, please do not use it;
· When cleaning is required, please gently wipe the surface of the meter with alcohol;
· If there is a problem with the product, please contact the manufacturer and do not attempt to repair it by yourself;
产品特性(Product Features)
· 测量偏差﹤0.5℃.(采用进口芯片及传感器);
· 测量时间﹤1秒,快速通行无压力;
· 24小时自动扫描监测体温,无需任何操作;
· 直接语音播报温度是否正常;
· 翻转式伸缩式延长探头,可调整探头前后方向及测量高度,对行人的位置姿势和胖瘦无要求;
· 设备采用全碳钢材质,外观喷塑,美观大方;
· Measurement deviation ﹤ 0.5 ℃. (Using imported chips and sensors);
· Measurement time: 1 second, fast passage without pressure;
· 24-hour automatic scan to monitor body temperature without any operation;
· Direct voice broadcast whether the temperature is normal;
· Flip-type telescopic extension probe, which can adjust the frontback direction and measurement height of the probe, and has no requirements on the position and posture of pedestrians and fatness;
· The equipment is made of full carbon steel, with a plasticsprayed appearance, which is beautiful and generous;
技术参数(technical parameter)
显示分辨率(display resolution) |
0.1℃ |
精度(Precision) |
±0.5℃ |
测量范围(Measuring range) |
27℃-42℃ |
功率(power) |
25W |
工作环境温度(Working temperature) |
10℃~40℃ |
工作环境湿度 (Working environment humidity) |
≦85% |
输入电压(Input voltage) |
DC 220V |
尺寸(size) |
外尺寸(External dimensions):2200×820×300 mm 通道尺寸(Channel size):1980×700×300 mm |
安装说明(Installation Notes)
· 该产品为成品组装完成出货,客户无需再次进行组装;
· 安装位置确认后,根据地脚膨胀螺栓孔位置确定打孔;
· 用M10的砖头打深度60mm的孔;
· 用附带的M8×60的膨胀螺栓把仪器固定在地面上;
· 把仪器电源线接到220V电源上。仪器安装完成;
· The product is assembled and shipped for the finished product, and the customer does not need to assemble it again;
· After confirming the installation position, determine the drilling according to the position of the anchor bolt holes;
· Make holes with a depth of 60mm with M10 bricks;
· Fix the instrument to the ground with the included M8 × 60 expansion bolts;
· Connect the instrument power cord to a 220V power source. Instrument installation is complete;
产品使用(Product use)
· 打开仪器开关,即可使用仪器;
· 人在通过体温检测门时,抬头眼睛看向红外热成型探头,无需停顿通过测温门,仪器语音播报“体温正常”,表示体温正常。若出现发烧症状,仪器会发出“体温异常”语音播报;
· Turn on the instrument switch to use the instrument;
· When a person passes through the temperature detection door, looks up at the infrared thermoforming probe, and there is no need to pause to pass through the temperature measurement door. The instrument broadcasts "normal body temperature", indicating that the body temperature is normal. If there is a fever, the instrument will send a voice report of "abnormal temperature";
参数设置(parameter settings)
·在仪器“主界面”点击“菜单”按钮,进入菜单界面,可对“检测人数”及“温度异常数”清零,并对报警温度值进行设置;
·长按“菜单界面”中的“传感器参数”按钮2S,如弹出登录界面,输入传感器登录密码为“123”,进入“传感器设置界面”。传感器参数在出厂前已设置,客户无需调整,如需调整,请联系厂家技术人员;
·点击“菜单界面”中的“数据记录”按钮,弹出“数据记录界面”,在数据记录界面可对数据进行查询、删除等操作!
· Click the "Menu" button in the "Main Interface" of the instrument to enter the menu interface, you can clear the "Number of testers" and "Temperature abnormal number", and set the alarm temperature value;
· Press and hold the "Sensor Parameter" button 2S in the "Menu Interface". If the login interface pops up, enter the sensor login password as "123" to enter the "Sensor Setting Interface". The sensor parameters have been set before leaving the factory, and the customer does not need to adjust. If you need to adjust, please contact the manufacturer's technical staff;
· Click the "Data Record" button in the "Menu Interface" to pop up the "Data Record Interface". You can query and delete data on the data record interface!
日常维护(Routine maintenance)
· 使用过程中请勿遮盖探头,如探头有损坏,请联系厂家更换。
· Do not cover the probe during use. If the probe is damaged, contact the manufacturer for replacement.
免责声明:当前页为 学校 工厂 红外测温门 LB-105门式红外测温仪 Infrared temperature door产品信息展示页,该页所展示的 学校 工厂 红外测温门 LB-105门式红外测温仪 Infrared temperature door产品信息及价格等相关信息均有企业自行发布与提供, 学校 工厂 红外测温门 LB-105门式红外测温仪 Infrared temperature door产品真实性、准确性、合法性由店铺所有企业完全负责。世界工厂网对此不承担任何保证责任,亦不涉及用户间因交易而产生的法律关系及法律纠纷,纠纷由会员自行协商解决。
友情提醒:世界工厂网仅作为用户寻找交易对象,就货物和服务的交易进行协商,以及获取各类与贸易相关的服务信息的渠道。为避免产生购买风险,建议您在购买相关产品前务必确认供应商资质及产品质量。过低的价格、夸张的描述、私人银行账户等都有可能是虚假信息,请您谨慎对待,谨防欺诈,对于任何付款行为请您慎重抉择。
投诉方式:fawu@gongchang.com是处理侵权投诉的专用邮箱,在您的合法权益受到侵害时,请将您真实身份信息及受到侵权的初步证据发送到该邮箱,我们会在5个工作日内给您答复,感谢您对世界工厂网的关注与支持!